Important Safety Warning

Always depressurize air and damper circuits before disassembly. If your shock or fork is still pressurized, removing the eyelet,sealhead or opening the damper in genreal can cause injury or damage.

8mm Shaft Clamp

Designed for 8mm shafts used in forks, dampers, and some coil shocks. Not compatible with air shocks unless the eyelet is removed. Most air shocks require a horizontal shaft clamp instead.

Product photo shows a 3/8″ (9.5mm) clamp, actual 8mm version may differ.

What It Does

This clamp securely holds 8mm shafts in your bench vise for service. Ideal for removing eyelets, damper pistons, rebound assemblies, or air pistons in forks. It fits tightly and safely, when used properly.

• Fits: Some Cane Creek DB Coil shocks (8mm versions only which are the older ones)
• Fits: 2020+ FOX FIT4 dampers
• Common use: Fork internals and small damper jobs
• Not for air shocks with eyelets attached, use horizontal clamp instead

Tip: Some Cane Creek DB Coil models now use a 9.5mm shaft instead. Confirm before clamping, 8mm clamps will not fit oversized shafts.

Setup Instructions

• Clean the shaft thoroughly with isopropyl alcohol,multiple passes
• Wrap the shaft in a dry paper towel before clamping
• Apply even vise pressure; do not overtighten
• Heat any Loctited part, FOX often uses red Loctite on eyelets

Read the full shaft clamp usage guide

Match Your Torque: Use our luggage scale torque calculator to safely estimate torque on your eyelet or damper shaft.

Reminder: Improper cleaning, oily shafts, or using the wrong clamp size will lead to slippage and clamp damage. If it doesnt fit easily, double-check your shaft diameter and ensure the clamp is fully seated.

Disclaimer

These clamps are for home mechanics only. Improper use can cause shaft or clamp damage. Always follow proper technique. By purchasing this product, you agree to our terms of service.